# # /etc/rc.conf - Main Configuration for Arch Linux # # # ----------------------------------------------------------------------- # LOCALIZATION # ----------------------------------------------------------------------- # # LOCALE: available languages can be listed with the 'locale -a' command # HARDWARECLOCK: set to "UTC" or "localtime" # TIMEZONE: timezones are found in /usr/share/zoneinfo # KEYMAP: keymaps are found in /usr/share/kbd/keymaps # CONSOLEFONT: found in /usr/share/kbd/consolefonts (only needed for non-US) # CONSOLEMAP: found in /usr/share/kbd/consoletrans # USECOLOR: use ANSI color sequences in startup messages # LOCALE="en_US.utf8" HARDWARECLOCK="UTC" TIMEZONE="US/Central" KEYMAP="us" CONSOLEFONT= CONSOLEMAP= USECOLOR="yes" # # ----------------------------------------------------------------------- # HARDWARE # ----------------------------------------------------------------------- # # Scan hardware and load required modules at bootup MOD_AUTOLOAD="yes" if [ -f /etc/systemconfig ] then . /etc/systemconfig fi if [ x$Audiotype = xOSS -a ! -f /tmp/.alsatest ] then ALSABLACKLIST="!soundcore" else if [ x$Audiotype = xOSS ] then ALSABLACKLIST="!soundcore" else ALSABLACKLIST="" fi fi # Module Blacklist - modules in this list will never be loaded by udev MOD_BLACKLIST_=($ALSABLACKLIST !snd-pcsp ) # # Modules to load at boot-up (in this order) # - prefix a module with a ! to blacklist it # MODULES=($MOD_BLACKLIST_) # Scan for LVM volume groups at startup, required if you use LVM USELVM="no" # # ----------------------------------------------------------------------- # NETWORKING # ----------------------------------------------------------------------- # HOSTNAME=`cat /etc/hostname` #The following is only used on the install. After the first boot everything is set from /etc/net. # # Use 'ifconfig -a' or 'ls /sys/class/net/' to see all available # interfaces. # # Interfaces to start at boot-up (in this order) # Declare each interface then list in INTERFACES # - prefix an entry in INTERFACES with a ! to disable it # - no hyphens in your interface names - Bash doesn't like it # # Note: to use DHCP, set your interface to be "dhcp" (eth0="dhcp") # lo="lo 127.0.0.1" #eth0="dhcp" INTERFACES=(lo ) # # Routes to start at boot-up (in this order) # Declare each route then list in ROUTES # - prefix an entry in ROUTES with a ! to disable it # gateway="default gw 192.168.0.1" ROUTES=(!gateway) # # Enable these network profiles at boot-up. These are only useful # if you happen to need multiple network configurations (ie, laptop users) # - set to 'menu' to present a menu during boot-up (dialog package required) # - prefix an entry with a ! to disable it # # Network profiles are found in /etc/network-profiles # #NET_PROFILES=(main) # # ----------------------------------------------------------------------- # DAEMONS # ----------------------------------------------------------------------- # # Daemons to start at boot-up (in this order) # - prefix a daemon with a ! to disable it # - prefix a daemon with a @ to start it up in the background # #DAEMONS=(syslog-ng network netfs crond) DAEMONS=(fbsplash !syslog-ng !hotplug !pcmcia network !mysqld !dbus !avahi-daemon) # End of file