show_link() { echo "----" echo "> You can find all missed scripts and config files on https://bitbucket.org/TZ86/arch-rcscripts" echo "----" } # arg 1: the new package version # arg 2: the old package version post_upgrade() { if [ "$(vercmp $2 2011.06.1)" -lt 0 ]; then echo "Blacklisting of modules is no longer supported in rc.conf," echo "please add blacklist entries to /etc/modprobe.d/ instead." fi if [ "$(vercmp $2 2011.07.2)" -lt 0 ]; then echo "VERBOSE= in rc.conf no longer has any effect." echo "Please append 'quiet' to your kernel command line." fi if [ "$(vercmp $2 2011.10.1)" -lt 0 ]; then echo "If using non-bash-compatible shell, please set LANG in /etc/locale.conf," echo "as LOCALE in /etc/rc.conf no longer works." fi if [ "$(vercmp $2 2012.08.1)" -lt 0 ]; then echo "----" echo "> initscripts now ships a compatibility layer to make systemd use DAEMONS" echo "> from rc.conf; and run rc.local and rc.local.shutdown on boot and" echo "> shutdown, respectively. Refer to arch-modules-load(8) and arch-daemons(8)." echo "----" fi if [ "$(vercmp $2 2013.10.1)" -lt 0 ]; then show_link fi } post_install() { echo "----" echo "> All localization parameters, network and kernel modules settings has been" echo "> moved to rc.conf. Systemd configs (such as vconsole.conf) is still supports" echo "> but is not recommended." echo echo "> Please note that now rc.conf overrides systemd configs. If you want keep" echo "> using systemd configs, just leave the corresponding parameter in rc.conf" echo "> commented out." echo "----" show_link }