1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
|
# SPDX-FileCopyrightText: no
# SPDX-License-Identifier: CC0-1.0
#
# Configuration for the preserve-files job
#
# The *files* key contains a list of files to preserve. Each element of
# the list should have one of these forms:
#
# - an absolute path (probably within the host system). This will be preserved
# as the same path within the target system (chroot). If, globally,
# *dontChroot* is true, then these items will be ignored (since the
# destination is the same as the source).
# - a map with a *dest* key. The *dest* value is a path interpreted in the
# target system (if the global *dontChroot* is true, then the host is the
# target as well). Relative paths are not recommended. There are two
# ways to select the source data for the file:
# - *from*, which must have one of the values, below; it is used to
# preserve files whose pathname is known to Calamares internally.
# - *src*, to refer to a path interpreted in the host system. Relative
# paths are not recommended, and are interpreted relative to where
# Calamares is being run.
# Exactly one of the two source keys (either *from* or *src*) must be set.
#
# Special values for the key *from* are:
# - *log*, for the complete log file (up to the moment the preservefiles
# module is run),
# - *config*, for a JSON dump of the contents of global storage.
# Note that this may contain sensitive information, and should be
# given restrictive permissions.
#
# A map with a *dest* key can have these additional fields:
# - *perm*, is a colon-separated tuple of <user>:<group>:<mode>
# where <mode> is in octal (e.g. 4777 for wide-open, 0400 for read-only
# by owner). If set, the file's ownership and permissions are set to
# those values within the target system; if not set, no permissions
# are changed.
# - *optional*, is a boolean; if this is set to `true` then failure to
# preserve the file will **not** be counted as a failure of the
# module, and installation will proceed. Set this for files that might
# not exist in the host system (e.g. nvidia configuration files that
# are created in some boot scenarios and not in others).
#
# The target path (*dest*) is modified as follows:
# - `@@ROOT@@` is replaced by the path to the target root (may be /).
# There is never any reason to use this, since the *dest* is already
# interpreted in the target system.
# - `@@USER@@` is replaced by the username entered by on the user
# page (may be empty, for instance if no user page is enabled)
#
#
#
files:
- from: log
dest: /var/log/Calamares.log
perm: root:root:644
- from: config
dest: /var/log/Calamares-install.json
perm: root:root:644
# - src: /var/log/nvidia.conf
# dest: /var/log/Calamares-nvidia.conf
# optional: true
# The *perm* key contains a default value to apply to all files listed
# above that do not have a *perm* key of their own. If not set,
# root:root:0400 (highly restrictive) is used.
#
# perm: "root:root:0400"
|
